Jump to content
Not connected, Your IP: 18.226.226.158
Sign in to follow this  
matte

Inactivity timeout??

Recommended Posts

This problem started about 2 weeks ago, i pasted the Viscosity log below.

 

Aug 08 13:17:03: Initialization Sequence Completed

Aug 08 16:54:44: Viscosity Mac 1.4.4 (1138)

Aug 08 16:54:44: Viscosity OpenVPN Engine Started

Aug 08 16:54:44: Running on Mac OS X 10.7.5

Aug 08 16:54:44: ---------

Aug 08 16:54:44: Controllo la raggiungibilità della connessione…

Aug 08 16:54:44: Connessione raggiungibile, inizio connessione.

Aug 08 16:54:46: OpenVPN 2.3.2 i386-apple-darwin [sSL (OpenSSL)] [LZO] [PKCS11] [MH] [iPv6] built on Jun  7 2013

Aug 08 16:54:46: UDPv4 link local: [undef]

Aug 08 16:54:46: UDPv4 link remote: [AF_INET]84.39.116.179:443

Aug 08 16:54:52: [server] Peer Connection Initiated with [AF_INET]84.39.116.179:443

Aug 08 16:54:54: TUN/TAP device /dev/tun0 opened

Aug 08 16:54:54: do_ifconfig, tt->ipv6=0, tt->did_ifconfig_ipv6_setup=0

Aug 08 16:54:54: /sbin/ifconfig tun0 delete

Aug 08 16:54:54: NOTE: Tried to delete pre-existing tun/tap instance -- No Problem if failure

Aug 08 16:54:54: /sbin/ifconfig tun0 10.4.14.130 10.4.14.129 mtu 1500 netmask 255.255.255.255 up

Aug 08 16:54:54: Initialization Sequence Completed

Aug 08 17:44:07: [server] Inactivity timeout (--ping-restart), restarting

Aug 08 17:44:07: SIGUSR1[soft,ping-restart] received, process restarting

Aug 08 17:44:08: UDPv4 link local: [undef]

Aug 08 17:44:08: UDPv4 link remote: [AF_INET]84.39.116.179:443

Aug 08 17:44:24: [server] Peer Connection Initiated with [AF_INET]84.39.116.179:443

Aug 08 17:44:27: TUN/TAP device /dev/tun0 opened

Aug 08 17:44:27: do_ifconfig, tt->ipv6=0, tt->did_ifconfig_ipv6_setup=0

Aug 08 17:44:27: /sbin/ifconfig tun0 delete

Aug 08 17:44:27: NOTE: Tried to delete pre-existing tun/tap instance -- No Problem if failure

Aug 08 17:44:27: /sbin/ifconfig tun0 10.4.14.130 10.4.14.129 mtu 1500 netmask 255.255.255.255 up

Aug 08 17:44:27: Initialization Sequence Completed

Aug 08 19:08:09: [server] Inactivity timeout (--ping-restart), restarting

Aug 08 19:08:09: SIGUSR1[soft,ping-restart] received, process restarting

Aug 08 19:08:10: UDPv4 link local: [undef]

Aug 08 19:08:10: UDPv4 link remote: [AF_INET]84.39.116.179:443

Aug 08 19:09:10: [uNDEF] Inactivity timeout (--ping-restart), restarting

Aug 08 19:09:10: SIGUSR1[soft,ping-restart] received, process restarting

Aug 08 19:09:10: UDPv4 link local: [undef]

Aug 08 19:09:10: UDPv4 link remote: [AF_INET]84.39.116.179:443

Aug 08 19:09:12: [server] Peer Connection Initiated with [AF_INET]84.39.116.179:443

Aug 08 19:09:14: TUN/TAP device /dev/tun0 opened

Aug 08 19:09:14: do_ifconfig, tt->ipv6=0, tt->did_ifconfig_ipv6_setup=0

Aug 08 19:09:14: /sbin/ifconfig tun0 delete

Aug 08 19:09:14: NOTE: Tried to delete pre-existing tun/tap instance -- No Problem if failure

Aug 08 19:09:14: /sbin/ifconfig tun0 10.4.14.130 10.4.14.129 mtu 1500 netmask 255.255.255.255 up

Aug 08 19:09:14: Initialization Sequence Completed

 

When this happens it's like turning on and off the router, because i can't navigate even if i'm not connected to the VPN. The connection restart itself randomly. Can be a ISP problem or VPN? I have this problem with all the server that i tried. Sometimes after 10 minutes, sometimes after 2 hours.

Share this post


Link to post

Hello!

 

It looks like a communication problem in any point between you and the VPN server. The fact that you need to reset or power cycle your router, and that after that everything goes back to normal, suggests that it's either a router crash or some "defense system" of your ISP or your router which wrongly identifies the OpenVPN UDP traffic as an UDP flood attack (when you connect to a VPN server over UDP, all of your outgoing and incoming traffic is over UDP).

 

Kind regards

Share this post


Link to post

I don't power cycle the router, it reset the connection itself. I have always been using this router, is a Cisco X3000 and i never had problems. Now i remember that this problem happened also without being connected to the vpn, just one time.

 

There is a IPv4 firewall protection SPI on my router settings, should i disable it?

Share this post


Link to post

I don't power cycle the router, it reset the connection itself. I have always been using this router, is a Cisco X3000 and i never had problems. Now i remember that this problem happened also without being connected to the vpn, just one time.

 

Hello,

 

ok, so it is probable that it's just a router problem.

 

There is a IPv4 firewall protection SPI on my router settings, should i disable it?

 

Yes, please disable it (it is anyway useless when you're connected to a VPN server, because it sees only encrypted traffic, so it can't inspect anything) and test whether the problem is solved.

 

Kind regards

Share this post


Link to post

After 5 minutes i was connected to the VPN the connection restarted, this happened 2 times in about 10 minutes. And if is a defense system of my ISP as you said before how can i solve this?

 

 

UPDATE: I'm using a different router. It seems to work now.

Share this post


Link to post

I'm still having this problem, i think it started when i installed stunnel. I never used it, just installed. I tried to find how to uninstall it on Mac OS  but nothing. Any help on how to uninstall it or check if it's working in background.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Security Check
    Play CAPTCHA Audio
    Refresh Image
Sign in to follow this  

×
×
  • Create New...