bypass vpn for certain ip address

[Tank 0]

finally got everything running fine with the vpn on dd-wrt

now i want to know if there is a way to use bypass the vpn for like my xbox and my microcell, i have static ip's on both of them

[Staff 9972]

finally got everything running fine with the vpn on dd-wrt

now i want to know if there is a way to use bypass the vpn for like my xbox and my microcell, i have static ip's on both of them

Hello!

Yes, DD-WRT supports Policy Based Routing with multiple routing tables:

http://www.dd-wrt.com/wiki/index.php/Policy_Based_Routing

So you might say, for example, that 192.168.1.101 uses the tunnel, while 192.168.1.102 does not.

Kind regards

[MrConducter 11]

Is there a way to allow a connection to my XBOX while connected to Air without dd-wrt? Also when I have my firewall (Comodo) blocking all traffic not through Air, how do I allow my XBOX and computer to communicate? I tried allowing all local to local but it is not working. Thanks!

[Staff 9972]

Is there a way to allow a connection to my XBOX while connected to Air without dd-wrt? Also when I have my firewall (Comodo) blocking all traffic not through Air,

Hello!

As far as we know it's not possible to run OpenVPN on a Xbox, but you might connect the Xbox with an Ethernet cable to a computer which acts as a gateway. The computer establishes the connection to an Air server, then allows Internet sharing to the Xbox.

how do I allow my XBOX and computer to communicate? I tried allowing all local to local but it is not working. Thanks!

Please determine the Xbox IP address in your network if it's static or tell us whether it accepts a DHCP-pushed IP from the router and send us your Comodo rules, Network Zones and how your local network is defined.

We're looking forward to hearing from you.

Kind regards

[Tank 0]

so just to be clear im doing this right before i do it, i would do somthing like this

ip rule add from 192.168.1.101 table 200

ip route add default via [gateway] dev [interface] table 200

ip route flush cache

and i get gateway from status-wan page

and get interface from setup-networking and at the bottom its says wan port assignment eth1

does that look correct