Raspbian / OpenVPN connection problems

[joseluis 1]

Hey guys, I currently have a Pi (Latets raspbian lite) connected to my hub via ethernet. I have OpenVPN and using to connect to a .ovpn I've generated from the config generator. It connects fine and I get a tun0 interface. However I then get no connection to the outside world.

 

ip addr:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
    link/ether x:x:x:x:x ff:ff:ff:ff:ff:ff
    inet 192.168.0.15/24 brd 192.168.0.255 scope global eth0
       valid_lft forever preferred_lft forever
    inet6 x:x:x:x:x:x:x/64 scope link 
       valid_lft forever preferred_lft forever
3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000
    link/ether x:x:x:x:x:x brd ff:ff:ff:ff:ff:ff
    inet6 x:x:x:x:x:x:x/64 scope link tentative 
       valid_lft forever preferred_lft forever
4: tun0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN group default qlen 100
    link/none 
    inet 10.4.63.73/16 brd 10.4.255.255 scope global tun0
       valid_lft forever preferred_lft forever

 

route:

Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default         10.4.0.1        128.0.0.0       UG    0      0        0 tun0
default         192.168.0.1     0.0.0.0         UG    202    0        0 eth0
10.4.0.0        *               255.255.0.0     U     0      0        0 tun0
128.0.0.0       10.4.0.1        128.0.0.0       UG    0      0        0 tun0
192.168.0.0     *               255.255.255.0   U     202    0        0 eth0
213.152.162.148 192.168.0.1     255.255.255.255 UGH   0      0        0 eth0

 

 

traceroute google.com

 

google.com: Name or service not known
Cannot handle "host" cmdline arg `google.com' on position 1 (argc 1)

 

When I try ping it just hangs with no output.

[LZ1 673]

Hello!

 

There's a guide to something similar, in case that's useful . Or at least you may know who to ask.